🎵 Elevate your vinyl vibe—because your records deserve the spotlight!
The PyleMini Phono Turntable Preamp converts low-level phono signals into high-fidelity line level output with ultra-low noise amplification. Featuring 3mV input sensitivity and stereo RCA inputs/outputs, it effortlessly connects any turntable to modern audio systems without specialized phono inputs. Its compact design and 12V DC power adapter make it an essential upgrade for audiophiles seeking crisp, clear vinyl sound.
N**Y
Excellent entry-level phono/turntable preamp!
This little box just works and I love it. I bought a vintage turntable that needed a lot of tender love and care and when I was finished, I bought this phone preamp to test it out and it works just great. To all the people that complain about buzzing you need to ground this connect the ground on the preamp device to your turntable and the buzzing will go away and it won’t work wonderfully.
M**L
Works great!
This works great! The built in amp for my turntable was not amplifying to an acceptable level and picking up lots of noise. With this the noise went away and the sound is not at an acceptable level.
T**M
Worked well for a mag cartridge but watch power supply!!
This model's 12V power supply output is not at ground.This means if you substitute the switching version with an analog one, the power supply cannot be grounded.BE WARNED!Otherwise it works just fine.
T**Y
Good product, but it has the wrong Resistors!
It's a good product, but there seems to be a wrong component. After receiving the goods, I couldn't wait to get it into the sound system, but the sound was obviously distorted, and the amplifier panel showed that the signal was too strong. After checking, there are two 820 ohm feedback resistors in the circuit diagram , but there were two 47 ohm resistors on the PCB board, which caused too large amplification and overload distortion. I replaced them with 1k ohm resistors, and then everything working good. I still leave 5 stars, but I hope the customer service or someone else can explain it.
D**D
This preamp WILL handicap your setup
I don’t typically bother writing negative reviews but I felt it was important to let people who may not know any better know what they’re getting into with this preamp. I kind of knew it wouldn’t be that great given the price. But I saw plenty of positive reviews so I figured I’d give it a shot. Well, I tried it with two different turntables and two different sets of speakers. The sound quality is frankly abysmal. It adds tons of unwanted distortion, and is particularly noticeable in vocals.If you are just getting into vinyl or getting your first setup you might not know any better. And it could sound passable enough. But if you know what your records/setup are actually supposed to sound like you’ll be immediately disappointed.Yes it is dirt cheap and I know it’s tempting. But believe me, this thing will make your listening experience so much worse than it needs to be. I ended up getting the Fluance preamp, which admittedly is like 7x the price. But the difference is absolute night and day. I’m sure there are plenty cheaper than the Fluance that work just great. But this Pyle preamp just isn’t it.If you’re splashing out on a nice turntable and/or speakers (or even “okay” ones), don’t let a junky preamp handicap the whole thing.
W**N
Good noise reduction for a low cost version.
So I dug out my old amp and preamp after sitting in a closet since my son was born. 17 years later it was time to get the old workhorse going again. My very old phono preamp was giving allot of noise. So I went looking for one and no luck at Best Buy. So I looked here and a few other high end stores. They had some really nice tube preamp that were really cool. But I went for the $15 one here. Works fine and my records sound warm and natural.
A**R
Opt for a more expensive preamp
If you have any knowledge of music whatsoever, spring for a more expensive preamp. I got this with low expectations, and the sound distortion is still bad enough that I wish I had opted for a better preamp. Vocals sound “buzzy” regardless of volume level. I adjusted the ground wire and swapped out cords for newer ones. Still sounds pretty awful. The only way I am able to cut down on the distortion is to turn the treble and bass all the way down while the volume is set to mid-range.The good news? It’s loud. I missed hearing my LP’s, so I get to listen to them now. But knowing that they could sound clear and crisp instead of buzzy and muddled really ruins the experience. Also, the volume control is either way too loud or too quiet and no in-between.For context, I have a vintage record player with AV cords and a ground wire. I have new speakers intended to be used with turntables. And I do have college degrees in music. My ex had this turntable hooked up to an Onkyo receiver and the sound was near-perfect. I wasn’t expecting perfection, just to hear my records again. Well now I can, but the sound quality is so poor that I will be springing for a more expensive preamp at first opportunity.No, really. It’s poor sound quality. But would get the job done for someone who doesn’t mind a muddled sound.
C**4
Very good adaptor
Works well
Trustpilot
5 days ago
1 week ago